Hot to build
Camera holder
How to build the new camera holder guide.
This is the new model of 3d printable camera holder.
All parts from this guide can be used with the SuperGreenLab construction set.
What you'll need
Selected region:
World
Click to change
SGL Construction Set BY SuperGreenTomato
From SuperGreenTomatoAll the parts used for the SGL kits.
Free DownloadTimelapse camera holder BY SuperGreenTomato
From SuperGreenTomato3D printed Raspberry Pi Zero + IR camera holder
Attach wrist
Attach wrist
Push the raspberry pi holder part into the arm's wrist.
Then add a 16mm screw to secure the holder in place.
Attach arm
Attach arm
Now attach the arm to the wrist, use a square nut on one side to screw everything together.
Attach arm to wall mount
Attach arm to wall mount
Now attach the wall mount to the wrist, use a square nut on one side to screw everything together.
Glue camera
Glue camera
Use some hot glue to attach the camera to the camera holder.
Best is to first place the camera, then add a few drops of glue on the screw holes.
Stack everything together
Stack everything together
Not clips the camera holder part to the rest, place the raspberry pi in the middle of the sandwich.
No need to add glue or screws, everything should hold together.
Done
Done
Good, now we're ready to put our camera in our box.
You can either use hot glue or strong double tape.
In both cases, don't forget to slightly sand-paper the surface before glueing, some furnitures have a very slick surface, which is not the best for adhesiveness.
Tighten the screws
Tighten the screws
Once the holder is glued to your furniture you can tighten the screws.
Don't over tighten is tho, just enough for it to stay in place.
Welcome to
checkout our dedicated grow lights and join the community!